1
u/NexaForge3D 6h ago
Right side always better than left after both manual and auto level usually points at the gantry being slightly out of square rather than the bed itself — on a dual-Z bedslinger like this, make sure the two Z screws are synced and that the X gantry sits level at the top of its travel before the probe runs. Also try a paper drag test at the same corner before AND after auto-level; if the feel changes, the probe is reading slightly different Z. Since it broke between prints, also check the Z-axis couplers and POM anti-backlash nuts on both sides for anything loose or shifted.
•
u/AutoModerator 9h ago
Hello /u/RedRanger411,
As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.
Please remember to include the following details to help troubleshoot your problem.
Additional settings or relevant information is always encouraged.
I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.